Design

 ​
1 Lifting handle, fibreglass-reinforced nylon
2 Testing hole for injecting compressed air to check the hermetic seal of the motor gaskets
3 Cable holder. The float switch cable can be fixed at various heights to start the pump at the fluid level required
4 Capacitor
5 Dry motor, with class F windings and built-in motor protection (for single-phase versions)
6 Pump body and motorcasing in stain-less steel AISI 304
7 Sealing system
8 Shaft in stainless steel AISI 304
9 Delivery port from 2” (50 mm) except DX(V) 35-5 with 1”1/2 ports (35 mm)
10 Impeller, vortex or channel type, in stainless steel AISI 304 (or fibreglass-reinforced nylon in the DXV 35-5)
– all elastomers in nitrile rubber (NBR)
– all screws and washers in stainless
   steel AISI 304