Monitoring equipment

All these pumps have temperature sensors in their windings and main bearings. Should liquid penetrate a pump's stator housing, a float-switch sensor positioned below the bearings and the stator-end coils will shut the pump down. Additional monitoring functions can be installed.

 

Approvals

All the pumps are approved in accordance with national and international standards (IEC 34-1, CSA). They are also available in explosion proof versions: Factory Mutual (FM) and European Norm(EN).

 

Corrosion protection

For corrosive applications, all these pumps can be equipped with zinc anodes, extra corrosion-resistant outer seal, epoxy coating, and stainless shaft and impeller.

 

Motor

Squirrel cage, high-performance, induction motor, specially designed for submersible applications and manufactured by ITT Water & Wastewater.

 

Bearings

Designed with one roller bearing and one or two angular-contact ball bearings.

 

Seals

Two sets of mechanical shaft-seals that work independently for double security. Designed, patented, and manufactured by ITT Water & Wastewater.

 

Oil housing

In addition to lubricating the seals, the oil-filled compartment dissipates heat from the motor and bearing. The housing also provides additional safety against penetration by liquids.

 

Wear rings

Easily replaced wear rings help maintain high pumping efficiency.